4
2.
Danger of electrical energy
Dangers of electrical energy may occur due to:
- Improper maintenance work on the electric parts, the use of NON-ORIGINAL PARTS on or near the , any
the electric parts, failure to pull the mains plug for maintenance work, running the equipment over the
mains cord or a defective cord or cable.
- Maintenance work and safety checks must only be carried out by authorized professionals.
- Immediately stop using defective equipment and make sure that it cannot be used by unauthorized users
again.
- Before starting to use the Gharieni “Pedispa Compact”, check the cabling (no damage). The mains lead
must not be run over nor overstretched during use.
- Interference with other electrical appliances can occur in certain situations.
- Make sure to provide electric power cable 3x12awg under GFCI breaker with the right voltage and Hz.
3.
Safety devices
GFCI breaker, plugs, Fuses, shielded cables and guards must be installed for personal safety. They must not
be removed, modified or by-passed.
REMEDY ANY DEFECTS IMMEDIATELY OR HAVE THEM REMEDIED IMMEDIATELY!
4.
Dangers due to mechanical energy
Beware: Risk of getting trapped! Always ensure that there are no objects or parts between the “Pedispa
Compact” body and the wall.
5.
Disposal
This equipment consists of metal and plastic parts, electronic components and electric cables.
The individual materials must be disposed of in accordance with the environmental and waste disposal
regulations of the country of use.
If you have any queries as regards disposal, contact the local authorities responsible for waste disposal,
your dealer or:
Gharieni GmbH
Tel.:
+49 (0)2841/88300-163
Fax:
+49 (0)2841/88300-999
Service Hotline: +49 (0)2841/88300-40
The equipment is delivered on a special pallet in a box. Carefully open the top of the box. Do not
use any sharp objects which might damage the equipment.
Do not lift the equipment, but first remove the upper carton cover. You can then lift the sleeve up
and put it aside.
Содержание Pedispa Compact
