8
9. Heater Smart Thermo
The lying surface of MLR can be heated to maximize the treatment comfort. You
can set 10 heating levels using the HCP (fig. 3). For quick heating of a cold lying
surface, after starting the heater will operate with max. power during the pre-
heating period. The parameters of the heater can be programmed and saved if
desired. Check the current temperature before using the MLR. Disconnect MLR
from the mains when it is not used for a longer period of time, e.g. during the
night.
9.1 Heater control panel
You can operate the heater using the 4 buttons ON/OFF/+/-.The setting of the
heating power is indicated by a 10-level LED bar-diagram. The green LEDs 1-4
indicate low power/low temperatures. The yellow LEDs 5-7 indicate medium
power/medium temperatures. The red LEDs 8-10 indicate high power/high
temperatures.
WARNING
1. Do not use the option Smart-Thermo when your customer
has got a pacemaker.
is pregnant.
is affected by thrombosis.
suffers from pain due to unknown reasons.
Apply to healthy people only
.
2. Do not exceed the default values set by the manufacturer (pre-
heating period approx. 6 minutes; treatment heating-level approx
30%, 3 LEDs)
when programming the heater yourself.
3. When the treatment is stopped prematurely, cancel the Smart-
Thermo function by pressing the OFF-button on the HCP to avoid
heat accumulation.
4. Disconnect the MLR from the mains when it is not used for a longer
period of time, e.g. during the night.
9.2 Heating
Switch on the heater using the ON-button on the control panel (fig. 3). The
preheating period starts on highest setting. After the pre-heating time has elapsed,
the normal treatment setting will start. You can stop the pre-heating period using
the + and - buttons and set the temperature to one of the 10 levels. Switch off the
heater using the OFF-button on the HCP.
