GGP ITALY NTL 430-R Li 80 series, Руководство оператора

Страница: 22 / 27

EN - 12
PROBLEM PROBABLE CAUSE REMEDY
3. The motor stops while
working and the machine
alarm buzzer is triggered
The thermal protection has tripped
due to overheating of the motor
Wait for at least 5 minutes and then restart
the machine
Thermal protection has tripped due to
excessive current absorption caused by:
• excessively high grass cutting
• obstructions that prevent
rotation of the cutting means
• too much grass debris accumulated in
the chassis and discharge channel
• Set a higher cutting height when the
grass is very tall, then set a lower
height and cut the lawn again
• Remove the obstructions (par. 7.3.2)
• Clean the machine (par. 7.3.1)
Wait for at least 5 minutes and then restart
the machine
4. The motor is running
but the cutting means
is stationary
The cutting means fittings are loose Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical Assistance
Centre for correct fastening support (par. 8.1)
5. The cut grass is
not collected in the
grass catcher
The cutting means has collided with a
foreign object and received a knock
Turn off the motor and remove the safety key.
Inspect for damage and
Contact a Technical Assistance Centre
for the replacement of the cutting
means if necessary. (par. 8.1)
The inside of the chassis is dirty Clean the inside of the chassis to
ease the grass discharge towards
the grass catcher (par. 7.3.2)
6. Mowing is difficult The cutting means is not
in good condition
Contact a Technical Assistance
Centre for the sharpening or
replacement of the cutting means
7. Excessive noise
and/or vibration
is experienced
whilst working
Cutting means fittings are loose or
the cutting means is damaged
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.2)
8. Battery power
reserve is low
Severe working conditions
requiring greater
current absorption
Optimise operations
(par. 7.2.1)
Battery is insufficient for
operating requirements
Use a second battery or an
extended battery (par. 15.1)
9. The battery charger
is not recharging
the battery
Battery is not correctly inserted
in the battery charger
Check it is correctly inserted (par. 7.2.3)
Unsuitable environmental conditions Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Dirty contacts Clean the contacts
The battery charger is not energised Check it is plugged in and the
power socket is energised
Faulty battery charger Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
If problems persist after having performed the above operations, contact your dealer.
All manuals and user guides at all-guides.com