3
CHAPTER 1
GENERAL DESCRIPTION
INDICATIONS
This apparatus should be installed in compliance with legislation in force and should be used in well ventilated
areas only. Read the instructions prior to installation and use.
For correct combustion the place where the grill is
installed must have at least minimum ventilation 10m³ / h of air per kW of heat input in operation. Consult
instructions before installation and use.
When installing the oven, you should follow the instructions and requirements of the gas supplier and, in any
case, contract an authorised technician to install it.
The apparatuses described below are for collective use and should only be handled by suitably qualified
personnel. This apparatus is model A: without fan.
DESCRIPTION OF THE APPARATUS
All vertical models are made in stainless steel except the components that are used to handle.
Basically, the following elements are present in the various models comprising the range of vertical ovens:
a) Structure
b) Transmission
c) Electric controls panel
d) Gas equipment
e) Doors
f)
Accessories
STRUCTURE
The dimensions of the part meant to support the various elements of the oven will depend on the number of
spits in the oven and on whether or not it is to be assembled on a base.
TRANSMISSION
The transmission of the apparatus is be chain which will make all the spits turn synchronically. Transmission is
moved by a motor reducer whose turnover speed is 4.5 r.p.m.
ELECTRIC EQUIPMENT
This comprises the motor described in the previous section and a luminous control switch situated at the bottom
left of the apparatus.
WARNING: The oven is connected to the mains at 230V for the gas models.
GAS EQUIPMENT
This consists of as many infrared burners, with their corresponding safety valves and thermocouples situated
one above the other and separated by an inter-burner sheet, as there are spits in the specific oven model.
It is all fed through a battery with a feed input of ½” gas.
DOORS
The doors consist of two panes of tempered glass with insulated handles. The glass panels are assembled on
the front of the oven. Their purpose is to protect you from the heat while the oven is in operation and to protect
the food from external agents.
WARNING:
Try not to hit the glass as they could break either at that moment or else later without any
apparent reason for their doing so.
Do not leave any burner on when the doors are closed unless there is food roasting on the spit in
question, the glass can explode.
Keep the glass clean and check that it is dry before each operation.
