INSTALLATION & TRANSPORT
5
OPERATING MANUAL
betriebshandbuch
4.3. installation & usage
When installing cooling cabinets, it is important to remember that they emit a lot of heat. If a shop is not adequately
ventilated, then this quickly leads to an
excessive rise in ambient temperature. This causes a persistently high condensation temperature and pressure
and a reduction in the effectiveness of the
cooling device. The device’s motor then has to operate in a state of overload and in extreme cases may lead to
permanent damage to the cooling device.
1).
Therefore it is recommended to:
● ensure a good ventilation of the room;
● periodically (often) check the cooling unit condenser (for fouling);
● set the refrigerated counter well away from any heat source (like radiators) and where it is not exposed
to direct sun;
● do not set the counter where it can be directly affected by fans (e.g. ceiling fans).
2).
To decrease the operation noise and to properly install the panes and as well to fully guarantee draining of the
condensate from drip pans, align the counter precisely horizontally. This can be achieved by means of four
adjusted legs
3).
The counter is checked and adjusted.
After plugging into power main, wait until a proper working temperature is reached and only then load the counter
with products, however, take care:
● that the load is stacked not higher than 20 cm;
● that products are distributed equally, keeping between product items gaps to allow cooling air to circulate
adequately;
● that inlet gaps for cold air are not blocked by products.
To maximally reduce the drying up of stored food products it is recommended to store them wrapped in air-tight
packaging, as well, as if possible to load into the
counter products already pre-cooled. Please, remember the greater the temperature difference between products
and the chamber, the greater the evaporating of water from products.
This water will sediment as hoarfrost on the condenser and consequently will additionally substantially impair the
cooling effect.
Setting the temperature level.
4.4. transport
The device needs to be carefully secured while being transported in order to protect it from shock and accidental
overturning. Glass parts and painted surfaced are especially sensitive to these types of dangers.
The device should remain in a horizontal position whether it is being transported, carried, or moved from one spot
to another.
●
press
(set-button)
for one second: the
preset temperature
will appear on the
screen;
● after two seconds, this number will begin
to blink;
●
increase or decrease this number using
these
two keys and, until you
reach
(set-button)
the desired tempe
-
rature level;
●
press again in order to confirm the
newly set temperature level;
0
I
0
I
set
CONTROL PANEL
display
system switch
C O O L I N G
light switch
Diagram 1. control panel
set
set
