MAINTENANCE & SAFETY
6
OPERATING MANUAL
betriebshandbuch
5. MAINTENANCE
User’s are responsible for on-going maintenance of the device by cleaning the cabinet’s interior and exterior
surfaces on a regular basis.
Cleaning should take place after the device has been disconnected from its power source using warm water along
with widely available cleaning dishwashing agents. After the device has been cleaned, perform the above-
mentioned actions in reverse order.
Do not use sharp tools to remove stains from interior and exterior surfaces. In the event that the interior lamp’s
light bulb becomes damaged or wears out, replace the old light bulb with a new one.
In order to accomplish this, disconnect the device from its power source (in order to prevent electric shock).
● remove the fluorescent lamp’s housing from the base
● remove the lamp from the clamps
● remove the sockets from the lamp
● replace the old lamp with a new one
● install the sockets
● insert the lamp into the clamps
● install the housing over the lamp assembly and connect the cabinet to a power source
In the event that the light bulb in the display illumination assembly becomes damaged or wears out, the following
steps need to be taken:
● disconnect the device from its power source (in order to prevent electric shock)
● remove the fluorescent lamp from the clamps
● remove the sockets from the lamp
● replace the old lamp with a new one
6. SAFETY CONSIDERATIONS AND WORKPLACE HYGIENE
1).
Do not plug the device into a power source until safety elements are installed.
2).
All installation work should be done by an authorized electrician.
3).
All repairs and adjustments to the electrical system may only be made by an authorized technician. In case
problems such as electrical
surges or sparking occur, immediately disconnect the device from power and call an electrician in order to fix the
problem.
4).
Washing and cleaning may only take place after power has been disconnected.
5).
If the permanently-fixed power cord becomes damaged, then it must be replaced through the manufacturer,
at a specialized repair facility,
or by a qualified technician in order to prevent injury.
