Gfp 563TH-4
December 2019
21
21. Rewind Assemblies
The unit comes with one standard lower rear rewind assembly. An additional optional rewind
assembly can be added to the lower front for special applications that require two-sided PSA
film to take up the release liner of the lower film supply.
An additional rewind/slitter assembly can be installed on the lower rear rewind area if side
slitting is required.
Installing the Rewind device:
1.
Remove 4 screws and inserts bolted inside each side frame
2.
Bolt rewind motor assembly to control side frame and rewind bracket to opposite side frame
where the inserts were located
3.
Slide cardboard core onto the rewind tube and insert the rewind tube onto the support
brackets
4.
Plug rewind motor into power plug outlet at the rear of the side frame
Operating rewind motor:
1.
Select “Combine” and the rewind shaft will match the speed of the laminator
2.
Select “Single” and the rewind shaft runs independent of laminator
3.
Adjust the speed or power of the rewind shaft with the Motor Torque knob
a.
As the diameter of the rear rewind roll gets larger and the roll gets heavier, the
motor may need additional torque or power to maintain the same speed as the
laminator
4.
Select “Forward” for the rewind motor to turn clockwise
5.
Select “Reverse” for the rewind motor to turn counterclockwise
6.
Adjust the Shaft Clutch to keep the rewind shaft turning at the same speed as the machine
output
a.
As the diameter of the rear rewind roll gets larger and the roll gets heavier, the clutch
may need to be tightened to keep the shaft clutch from slipping
Clutch adjustment
knob
