Gfp 563TH-4
December 2019
16
5.
Adjust the brake tension by turning the adjusting knob on top of the supply roll assembly
(see Brake tension adjustment section #15)
6.
Repeat process with bottom supply shaft using Mounting adhesive or printed media roll
7.
Position bottom supply roll using the same number position used on the top supply roll to
align top and bottom rolls
i.
When using printed media, position one Media Alignment Disk on each side of
the roll to keep edges lined up
ii.
Media rolls can be very slippery and ‘telescope’ when loading on the supply shaft
and running
(see picture below)
Bottom supply shaft with Media Alignment
Disks
NOTE:
Printed media can be very slippery
and will ‘telescope’ when loading on the
supply shaft. Use the alignment disks to keep
the edges properly lined up.
Media alignment disks
Brake adjustment knobs
Top supply shaft
