Electric connections
ATTENTION: before making the electric connections,
make sure all the equipment and cables are not powered.
Connect the network power supply (230 Vac) and the device
power supply cables (14.4 Vdc) to the corresponding screw termi-
nals, respecting the indications on the power supply label.
ATTENTION: do not exceed the permitted voltage and
current levels! Do not obstruct the ventilation openings!
Install a C curve, 16 A automatic, magneto-thermic bipo-
lar switch upstream in an easily accessible position.
Signalling
The presence of SELV voltage at the output is signalled by the red
LED switched on near the terminals.
Use a dry cloth to clean the audio/video power supply if necessary.
1 Audio/video power supply
1 Instruction sheet
Power supply
230 Vac ±10%, 50/60 Hz
Powered outputs
GW 18 361: 1 x 14.4 Vdc rated, SELV
GW 18 362: 2 x 14.4 Vdc rated, SELV
Maximum delivered power
GW 18 361: 18 VA
GW 18 362: 2 x 18 VA
Maximum dissipated power
GW 18 361: 3.9 W
GW 18 362: 6.9 W
Display elements
Red LED for signalling output voltage (one
per output)
Protections
Short circuit protected at the output
Usage environment
Indoor, protected from the rain and water
infiltrations
Operating temperature
0 ÷ +45 °C
Storage temperature
-15 ÷ +70 °C
Relative humidity
Max. 93% (non condensative)
Electric connections
Screw terminals, max. cable section:
2.5mm
2
Weight
0.12 kg
Degree of protection
IP20
Width (DIN modules)
4
Reference standards
Safety: 2006/95/EC, EN 60065
Electromagnetic compatibility:
2004/108/EC, EN 61000-6-1, EN 61000-6-3
Pack Contents
Technical data
In service
Device cleaning
