Getra 220 MT, Техническое руководство по эксплуатации

Страница: 10 / 33

- 8 -
2.2 Potential Hazards
Please observe the following notes carefully in order to avoid injuries and damage to materials!
Burn hazard!
The nozzle (1) and melted glue can reach temperatures in excess of 200°C. Avoid contact and, if
necessary, wear protective gloves.
Odor!
Hot melt adhesives release vapors that may cause odor nuisance. Improper use can, in some cases,
lead to irritation of the mucous membranes. Always ensure adequate ventilation.
2.3 Notes on Safe Operation
Please observe the following notes carefully in order to avoid malfunctions and incorrect
operation!
Keep all flammable or heat-sensitive materials away from the area around the nozzle (1).
The hot unit can be set down on the stand (2).
Never force the trigger (4).
Protect the unit against moisture and water.
Protection against electrical shock.
Follow the instructions on using hot melt adhesives.
Protection against improper gluing results.
If the unit is used with the nozzle facing upwards, always pay attention to the formation of glue droplets
in order to avoid burns to the operator or to work materials.
Before carrying out any work on the unit (maintenance, cleaning) always unplug it from the wall socket
outlet. After finishing your gluing task, unplug the unit from the wall outlet and allow it to cool down
before putting it away.
Always make sure the unit is plugged into a grounded wall outlet. When using an extension cord,
always inspect it for damage and make sure it is equipped with a ground wire.
3 Operating Instructions
Always observe the safety instructions cited in Chapter 2.
3.1 Startup
Plug the power cord (6) into a grounded outlet and switch the unit on at the ON/OFF switch (5).
The red power indicator light at the ON/OFF switch (5) goes on.
The unit immediately begins heating up.
If a glue stick has already been inserted, liquefied glue may emerge from the nozzle. Therefore, always
place the unit on an appropriate surface.
Allow the unit to heat up for between 6 and 8 minutes (depending on glue type).
Insert the hot melt glue stick into the opening on the back of the glue gun until the stick reaches the
black insulating sleeve (8).
6DIHW\2SHUDWLQJ,QVWUXFWLRQV