4
accept the negotiation of PBC mode.
Note:
Do not press the Reset button unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to restore the
default settings, please press the Reset button gently for 3 seconds with a fine
needle inserted into the hole and then release the button. The system reboots and
returns to the factory defaults.
Warning:
The power specification is 12V, 500 mA. If the power adapter does not match the
specification, it may damage the device.
2.3 Hardware Installation
2.3.1 System Requirements
Before installing the device, please make sure that the following items are ready.
At least one Ethernet RJ45 cable (10Base-T/100Base-T)
GR-534W
x
1
A PC has been installed PCP/IP protocol and it can access the Internet.
2.3.2 Before You Begin
Before you install the device, please pay attention to the following items:
When connecting the device to the computer, hub, router or switch, the
Ethernet cable should be less than 100 meters.
Do not place this device on an unstable surface or support. Do not put this
device on the ground.
Keep the device clean. Avoid the device from direct sunshine. Avoid any
metal in the device.
Place the device in the center of the area, and try to optimize the wireless
coverage.
2.3.3 Connecting AP
Step 1
Connect one end of the RJ45 cable to the LAN interface of the GR-534W.
Step 2
Connect the other end of the RJ45 cable to your PC.
Step 3
Connect the power adapter to the power socket of the GR-534W.
Содержание GR-534W
