getAir SmartFan X, Инструкция по установке и эксплуатации

Страница: 4 / 24

This document contains operating instructions for the SmartFan X. Though its contents have
been checked for consistency with the described hard- and software, deviations cannot be ruled
out, meaning that no guarantee of complete consistency can be given.
This documentation is updated on a regular basis. Necessary corrections and useful addenda
will always be included in subsequent versions.
They are also available at www.getair.eu/downloads/.
EN 4
1 General remarks
1.1 Use instructions
The SmartFan X is an exhaust fan for installation in the wall or ceiling. For each fan, a hole has to
be drilled in the wall or ceiling, through which a connection to a ventilation duct leading outwards
can be established. The outside opening must be covered by an appropriate grille.
The SmartFan X can be linked up either to a remote control or to an internal control module of-
fering a wide range of control options: a timer, humidity sensor, motion sensor or a combination
thereof. The optional modules can be installed on initial SmartFan X installation or at a later date.
The SmartFan X has a casing classed as IP X4. It is assigned to IEC Protection Class II (double
insulated electrical appliance) and can be installed in Zone 3 (bathrooms, toilets, kitchens and
workplaces).
The fan must not be installed close to a source of heat, for instance near a radiant heater or in a
location where the temperature can exceed 40°C.
1.2 Safety information
The following list contains descriptions of the symbols and terms used in these instructions:
Hazard symbol
Caution
This hazard symbol warns about the
danger of injury.
Electricity
This hazard symbol warns about the danger
of electrocution.
Warning symbol
Please
note This warning symbol indicates important
information.