To continue using the GESTRA program tap the
button "No".
To confirm that you want to exit the program tap
the button "Yes".
Data that have not been saved are stored in the
flash file system of the data collector and the
GESTRA program is closed.
Setting up the data collector
You can customize various settings of the GESTRA
program on the data collector according to your
needs.
Attention!
An incorrect setting can impair the proper
functioning of the equipment.
Change only the settings described in
the following.
Contact the manufacturer if you want
to change any other settings.
15
You can change the following settings:
the language of the menu of the GESTRA
program on the data collector
the Bluetooth connection between the data
collector and a Com Box
To change the language proceed as follows:
Switch on the data collector.
To open the main menu tap the button
"Continue".
Tap the button "Language".
A list of all available languages appears.
Tap button "Page up" or "Page down" until the
desired language is shown.
To select a language tap on the respective item.
To confirm you selection and show the menu in
the desired language tap the button "Continue".
The menu is shown in the selected language.
To return to the main menu without accepting
the new setting tap button "ESC".
The menu remains in the previous language.
To establish a Bluetooth connection (via pairing) for
data transfer between the data collector and a Com
Box proceed as follows:
Switch on the Com Box.
Switch on the data collector.
Make sure that the Bluetooth connection to the
data collector is active.
To open the main menu tap the button
"Continue".
Tap the button "Bluetooth".
The submenu "Com Box pairing" opens.
To find Bluetooth sources in the signal reception
area tap the button "Continue".
The display states "Looking for Com Boxes ...". The
data collector searches for Bluetooth sources at the
reception area. At the same time any existing
pairing with a Com Box will be deleted.
Once the search routine is finished, up to ten Com
Boxes ready for pairing will be indicated as buttons
specifying the respective name of the equipment.
The name of the equipment is "VKP40plus_xxxxxx“.
The serial number "xxxxxx" corresponds to the
number indicated on the name plate of the Com
Box. Any other devices sending Bluetooth signals
will not be shown.
To pair the equipment with the desired Com Box
tap the respective button.
The two devices are being paired. The display
states "Pairing mit VKP40plus_xxxxxx“ ". After the
pairing is complete the display states the message
"Successfully paired with VKP40plus_xxxxxx".
Tap the button "Continue".
Should an error occur during the pairing routine, the
message "Error during pairing" is shown.
In this case repeat the pairing process.
If the error message pops up again try to pair
the equipment with another Com Box.
If the equipment can be paired with another Com
Box, the Com Box is faulty. If the equipment cannot
be paired, the data collector is faulty.
In this case please contact the manufacturer.
