GESTRA ORGS 11-1, Руководство по установке

Страница: 21 / 24

21
If faults occur that are not listed above or cannot be corrected, please contact our service centre or
authorized agency in your country.
Removing and disposing of measuring electrode ORGS 111
Removing and disposing of measuring electrode ORGS 111
1. Close ball valves c and d .
2. Switch off supply voltage.
2. Undo cover screws
g
and remove the housing lid
h
.
3. Detach the connecting wires from the terminals
n
and pull wires out of the cable gland.
4. Before removing the equipment make sure that is is neither hot nor under pressure.
For the disposal of the measuring electrode observe the pertinent legal regulations concerning waste
disposal.
Safety note
Danger
When loosening the measuring electrodes hot cooling water may escape.
This presents the risk of severe scalding all over the body!
Do not remove the measuring electrode ORGS 11-1 unless the boiler pressure is verified
to be zero.
The terminal strip of the measuring electrode ORGS 11-1 is live during operation! This
presents the danger of electric shock!
Cut off power supply before mounting or removing the housing cover!
The equipment must only be installed and commissioned by qualified and competent staff.
Retrofitting and maintenance work must only be performed by qualified staff who - through adequate
training - have achieved a recognised level of competence.