Gestetner G056, Руководство по обслуживанию

Страница: 291 / 335

FIRMWARE UPDATE PROCEDURE
G056/G058 5-14 SM
5.4 FIRMWARE UPDATE PROCEDURE
5.4.1 CONTROLLER/NIB/ENGINE FIRMWARE UPDATE
This procedure is for upgrading the firmware of the machine.
1. Prepare 2 IC cards with the controller firmware.
2. Turn off the main switch.
3. Remove the IC card slot cover [A] on the rear side of the machine as shown.
4. Insert the IC card-1 [B] into slot [C] and turn on the main
switch. “Onboard Sys. 1/2” is displayed.
5. Press “# Enter.”
Note: Make sure that
∗
is displayed.
6. Scroll with the [
!
] [
"
] key and select “Update.”
Press “# Enter” to start downloading.
The “On Line” LED starts blinking and the machine starts
to download the program.
(Notice that the
∗
mark disappears as the program is
downloaded.)
7. When updating card-1 is finished, “Update 1/2 task done”
is displayed.
8. Turn off the main switch and replace the card with IC card-
2. Turn on the main switch, then downloading will
automatically start.
9. When updating card-2 is finished, “Update done” is
displayed. Then, remove the card, turn on the main switch
and print the configuration sheet. Check that controller
firmware is successfully updated.
G058R713.WMF
Onboard Sys. 1/2
Onboard Sys. 1/2
∗
Update
Updating
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
Update 1/2 task done
Updating
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
Update done
[A]
[B]
[C]
!
CAUTION
Do not turn off the machine while
downloading the firmware.
NOTE:
When you see the machine from the
back, the “A” side of the card must
face the right as shown.
⇒
Rev. 08/2001