Gestetner G056, Руководство по обслуживанию

Страница: 246 / 335

PRINTER ENGINE SERVICE MODE
G073/G074 5-6 SM
Mode Name Description Function /[Setting]
Set Network Job spool
(LPR) Job spool on/off (LPR).
0: Job spool off
1: Job spool on
Job spool (IPP) Job spool on/off (IPP).
0: Job spool off
1: Job spool on
Primary I/F Interface selection for the Ethernet or wireless LAN when
both interfaces are available.
0: Ethernet
1: IEEE802.11b (wireless LAN)
Note: This setting is same as the user mode setting “LAN
Type” in the Network Setup of the Host Interface menu.
Current I/F Displays the current interface setting (Ethernet or
wireless LAN).
HDD Init Initializes the
HDD Initializes the hard disk.
Use this only if there is a hard disk error.
Prog
Checksum
---
DFU
IEEE1394 DFU
IEEE802.11b Wireless LAN
available
channel setting Sets the maximum and minimum value for the wireless
LAN channel adjustment.
DFU
[0 to 14]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting, or the machine may be
out of compliance with local regulations.
USB settings
Transfer Rate
Adjusts the USB transfer rate.
HS/FS: High speed/Full speed auto adjust
(480Mbps/12Mbps)
FS Fixation: Full speed (12Mbps fixed)
Do not change the setting unless there is a data transfer
error using the USB high speed mode.
Vendor ID Displays the vendor ID. DFU
Product ID Displays the product ID. DFU
USB
Dev. Release
Num Displays the development release version number. DFU
Test Print Engine test
pattern print Prints the test pattern that was selected in the “Test
Pattern” mode.
Plug/Play Plug & Play
name selection Select the plug & play name.