Gesswein 510-2245, Инструкция по эксплуатации

Страница: 5 / 12

5
5.
Operating Procedure
With your New SZX Profiler adjusted for stroke and with a selected tool fitted, con-
nect the Gesswein Power Hand Controller to an electrical supply and the Profiler to
controller.
Set the Slide Rheostat on the Controller to “Low” or the “0” position. Put the Controller
Main Switch to the “ON” position, which lights up a pilot light that indicates your New
SZX Profiler is ready to use.
To increase the speed of the New SZX Profiler, move the Slide Rheostat toward High
or “10” and the desired reciprocating frequency. You can now begin working. When
work is completed, put the Main Switch to “OFF.”
To operate your handpiece using the optional Variable-Speed Foot Rheostat or
optional On/Off Foot Switch, please refer to the Power Hand 2X Controller Instruction
Manual for proper connection. The handpiece will not run until the foot rheostat/switch
is depressed. The rheostat provides infinitely variable speed control; the switch only
turns the handpiece on and off (operates at speed selected on controller).
8
New Z-SZX Parts List
When ordering spare parts, always specify part# (or item# if applicable) and
description.
Part# Item# Description
Z-SWX-101 Top Cover
Z-SWX-102 Oval Countersunk Set Screw (M2. 6 x 6)
Z-SWX-200 Swing Arm Completed
Z-SWX-201 Swing Arm Support B
Z-SWX-202 Swing Arm
Z-SWX-203 Tool Securing Screw
Z-SWX-204 Swing Arm Support A
Z-SWX-300 Eccentric Shaft Completed
Z-SWX-301 E-Type Clip Ring
Z-SWX-302 Ball Bearing
Z-SWX-303 Eccentric Shaft
Z-SWX-400 Main Shaft Completed
Z-SWX-401 Main Shaft
Z-SWX-402 Coil Spring
Z-SWX-403 Joint
Z-SWX-404 C-Type Clip
Z-SWX-405 Teflon Spacer
Z-SWX-406 Ball Bearing
Z-SWX-407 O-Type Rubber Ring
Z-SWX-408 Bearing Spacer
Z-SWX-409 C-Type Clip Ring
Z-SWX-420 Hexagon Socket Set Screw (M3 x 4)
Z-SWX-501 C-Type Clip Ring
Z-SWX-502 Wave Washer
Z-SWX-503 Lock Ring Completed
Z-SWX-002 Hexagon Key Wrench