DAN0812
21
9.
Store the appliance only after it has come to a complete standstill.
10.
Use a suction device to suck off wood shavings or dust. For this use the connecting pipe and connect a
suction pipe to it.
11.
Use a holding device to work on small work pieces.
12.
WARNING:
Wear hearing protection device, dust mask, safety goggle.
13.
WARNING:
Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the
surface leading to possible loss of control and serious injury.
OPERATION
SWITCH ON/OFF
CAUTION:
Before plugging the machine into the power supply always check that
the trigger switch and lock-off button are working properly.
Plug in the tool, push in the lock-off button and pull the trigger switch.
To stop the tool, simply release the trigger switch.
In order to restart the tool, it is necessary to operate both the lock-off button and the trigger switch.
This is an important safety feature that helps prevent accidental operation of the planer.
ADJUST THE DEPTH KNOB
CAUTION:
Always ensure that the tool is switched OFF and unplugged from the
power supply before making adjustments or installing or removing blades.
Rotate the depth adjustment knob clockwise for a deeper cut and
counter-clockwise for a shallower cut.
The numbers on the ring under the depth adjustment knob indicate the depth of
cut. E.g. when “2” is next to the pointer on the front of the planer, the depth of cut is approximately 2 mm.
If it is necessary to accurately determine the depth of cut, plane a scrap piece of wood, measure the difference in
thickness and adjust the setting.
CAUTION:
Always ensure that the number on the ring is at the “0” position when the tool is not in use; at this
position, the blade can not cut the workpiece.
PLANING
•
Rest the front base flat on the workpiece surface without the blades making any contact with the workpiece.
•
Switch on the tool and wait for the blades to reach full speed.
•
Move the tool gently forward, applying pressure on the front of the tool at the start of planing and pressure
at the rear of the tool (using your hand on the back handle towards the end of the planing stroke.
•
Push the planer beyond the edge of the workpiece without tilting it downwards.
NOTE:
Planing is easier if you incline the workpiece slightly away from you so that you plane “downhill”.
Содержание DAN0812
Страница 3: ...DAN0812 3 ...
Страница 25: ...DAN0812 25 ...
