X500pro
3D printer manual
DRAFT
German
RepRap
6.1 Establishing a Network Connection (DHCP-Based)
If your network settings are DHCP based, simply
connect the printer through a patch cable to
your local network. Doing so, the X500pro gets
automatically assigned an IP address.
You can see the printer´s assigned IP address on
the touch display in the menu
Network
.
The printer has an
internal
and an
external
IP-Address. Use the
external
IP-Address in order
to connect to your 3D printer.
Each of this IP adresse is linked to one of the
ethernet connectors on the rear side of the
printer.
Scan the QR-Code to control your 3D printer
using a mobile device.
6.2 Establishing a Direct Connection (Via Router)
If it is not possible to integrate your 3D printer into you local network, you can connect to it with you
computer using a DHCP-based router.
Fist connect the router to the power supply and afterwards connect your 3D printer as well as your
computer to it. Both devices will get IP-addresses assigned, which you can read out as described above.
7. Repetier-Server
Repetier-Server is an application for operating the X500pro 3D printer and initiating 3D prints. You can
access your printer from everywhere so it is possible to upload and manage G-Codes from remote. Here it is
also possible to check the print progress of your objects and to send individual commands to the 3D printer.
In addition to this it provides an easy way to upload firmware updates.
7.1 Web interface
The web interface provides full control of the X500pro, no matter if you work via a computer, a tablet or
even a smart-phone.
To access the web interface, enter the following address into your web browser:
• IPadress.of.your.3Dprinter:3344
• E.g.: 192.168.100.1:3344
Please note:
The IP-Base Address must not be identical!
Network Interfaces, Touch-Display
30/83
