P. 07
使用方法 Operating Procedures
1. 打開煲蓋
先用手握緊煲蓋手把，以【開蓋】 方向 (順時
針) 旋轉煲蓋至
位置A
(圖1、2)，然後向上提起
煲蓋 (圖3)
2. 取出內鍋，將食物和水放入內鍋中
食物和水不應低於內鍋高度的1/5 (圖4) 或超過內
鍋高度的4/5 (圖5) (水中易膨脹食物不得超過內鍋
高度的3/5) (圖6）
3. 內鍋置入全能飯煲
內鍋置入全能飯煲前，先把內外鍋及發熱盤抹拭
乾淨。煲內及發熱盤表面不得放入任何雜物；放
置好內鍋後，左右輕輕旋轉內鍋，以保持內鍋與
發熱盤接觸良好 (圖7）
1. Open Lid
Hold handle and turn lid to “OPEN LID” direction
(clock-wise) up to
position A
(Figures 1 & 2). Lift
cooker lid (Figure 3)
2. Put Water & Food
Take out the inner pot and then put food and water
in it. Food and water combined cannot be lower
than 1/5 or exceed 4/5 of the height of inner pot.
(Figures 4 & 5) (If food expands in water, water level
should not exceed 3/5 of pot height) (Figure 6)
3. Place Inner Pot In Cooker
Before placing inner pot into cooker, make sure
the outside of inner pot and heating plate are
clean. Position inner pot properly so that it is in
good contact with the heating plate (Figure 7)
1
2
3
4
5
6
7
A
B
A
A
B
B
