German pool PAC-215, Руководство пользователя

Страница: 8 / 27

P.15 P.14
Switch the unit of temperature
When the appliance is standby, press the button 20 seconds, then you can change the unit of
temperature.
For example:
Before change, in cool mode, the screen display looks like fig7.
After change, in cool mode, the screen display looks like fig8.
DRY mode
Ideal to reduce room humidity (spring and autumn, damp room, rain
filled periods, etc).
In dry mode, the appliance should be prepared the same way as cool
mode, with the air exhaust hose attached to enable the moisture to be
discharged outside.
To set this mode correctly:
• Press the button a number of times until the symbol appears.
• Select the required fan speed by pressing the button.
Three speeds are available:
Maximum speed: to achieve the best dehumidifying effect.
Medium speed: can reduce noise levels but still maintains a better dehumidify effect.
Low speed: for silent operation but lowers the dehumidifying effect relatively.
Fig 7 Fig 8
Operating Instructions
MODE FAN
TIMER SWING
SLEEP
ON/OFF
Fan button
Swing button
Sleep mode button
Increase button
Decrease button
On/Off button
Mode button
Timer button
Unit Switch button
Point the remote control at the receiver on the appliance.
The remote control must be no more than 7 meters away from the appliance (without obstacles
between the remote control and the receiver).
The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight
or sources of heat. If the remote control does not work, please try to take out the battery, and put it
back.
The remote comes with a battery already installed. To use the remote for
the first time, remove the transparent insulating strip from the battery
housing by gently pulling it out.
Replacing the Battery
To replace the battery, follow the steps below:
1) Press down the pin and remove the battery cover.
2) Replace the battery and reinstall the battery cover
into the remote controller.
MAX 7 metres
Operating Instructions
OPEARTING FROM THE REMOTE CONTROL
Note: Under dry mode the temperature cannot be adjusted, only wind speed can be adjusted.
Note: When indoor temperature is ≤16°C, compressor unit will not activate and dry mode will not be
available.
Insulating strip
Remove
Cover hole
Pin
(Accessories
not included)
Battery
cover
Battery
(type: CR2025)
Zoom in
Insert the pin to the cover
hole and then press
Push the cover out
at the same time