German pool PAC-215, Руководство пользователя

Страница: 11 / 27

P.21 P.20
TIMER function
This timer can be used to delay the appliance start-up or shutdown. This optimizes operating periods.
Programming start up
• Turn on the appliance, choose the mode you want, for example cool, 24°C, high
fan speed.
Turn off the appliance.
• Press the button, the screen will display 1-24 hours, and the symbol and
symbol and symbol will flash together. (fig 11)
• Press several times until the corresponding time is displayed. Wait for about
5seconds, the timer will be active, then only the symbol is displayed on
screen.(fig 12)
• Press the button or the button, the timer will be canceled, and the
symbol will disappear from screen.
Programming shut down
• When the appliance is running, press the button, the screen will display hours, and several
symbols will flash.(fig 13)
• Press several times until the corresponding time is displayed. Wait about 5 seconds, the timer will be
active, then only the symbol is displayed on screen.(fig 14)
• Press again the button or the button, the timer will be canceled, and the symbol will
disappear from the screen.
Fig 11
Fig 12
Fig 13 Fig 14 Fig 15
Operating Instructions
To optimize your appliance follow these recommendations:
• Close the windows and doors in the room to be air conditioned
(fig. 16).When installing the appliance semi-permanently, you should
leave a door slightly open (as little as 1 cm) to guarantee ventilation;
• Protect the room from direct exposure to the sun by partially closing
curtains and/or blinds to make the appliance much more economical
to run (fig. 17);
• Never rest objects of any kind on the appliance;
• Do not obstruct the air intake and outlet (fig. 18).
Leave the grilles free:
• Make sure there are no heat sources in the room
.
• Never use the appliance in very damp rooms (laundries for example).
• Never use the appliance outdoors.
• Make sure the appliance is standing on a level surface, if necessary,
place the castor locks under the front wheels.
When there is excess water condensation inside the unit, the appliance stops running and shows
“ ” (FULL TANK as mentioned in SELF-DIAGNOSE).
This indicates that the water condensation needs to be drained using the following procedures:
Manual Draining (fig.19)
Water may need to be drained in high humidity areas
1 .Unplug the unit from power source.
2. Place a drain pan (prepared by customer selfs) under the lower drain plug. See diagram.
3. Remove the lower drain plug.
4. Water will drain out and collect in the drain pan (prepared by customer selfs).
5. After the water is drained, replace the lower drain plug firmly.
6. Turn on the unit.
Operating Instructions
Tips For Correct Use
16
17
18
Water Drainage Method
close doors
and windows
close curtains
do not cover the
appliance