German pool PAC-215, Руководство пользователя

Страница: 13 / 27

P.25 P.24
PROBLEM
CAUSE
SOLUTION
• Position the air exhaust hose
correctly, keeping it as short and
free of kinks as possible to avoid
bottlenecks
• Check and remove any obstacles
obstructing air discharge
The appliance works, but
does not cool the room
• Windows, doors and/or curtains
open
• There are heat sources in the
room (oven, hairdryer, etc)
• The air exhaust hose is detached
from the appliance
• The technical specification of the
appliance is not adequate for the
room in which it is located
• Close doors, windows and cur-
tains, bearing in mind the “tips for
correct use” given above
• Eliminate the heat sources
• Fit the air exhaust hose in the
housing at the back of the appli-
ance
During operation, there
is an unpleasant smell in
the room
• Air filter clogged • Clean the filter as described
above
The appliance does not
operate for about three
minutes after restarting it
•The internal compressor safety
device prevents the appliance from
being restarted until three minutes
have elapsed since it was last
turned off
• Wait. This delay is part of nor-
mal operation
The following message
appears on the display:
• The appliance has a self
diagnosis system to identify a
number of malfunctions
• See the SELF-DIAGNOSIS
Chapter
• There are bends in the air
exhaust hose
• Something is preventing the air
from being discharged
The appliance works for a
short time only
• Wait
• Plug into socket
• Wait 30 minutes, if the problem
persists, contact customer service
center
• There is no current
• It is not plugged in
• The internal safety device has
tripped
The appliance does not
switch on
/ /
Troubleshooting
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are
displayed on the appliance display.
If Is Displayed What Should I Do?
The appliance is fitted with a frost protection device to
avoid excessive formation of ice.
The appliance starts operating again automatically when
the defrosting process is completed.
If this is displayed, contact customer service centre.
Empty the internal safety tank, following the instructions in
the “End of season operations” paragraph.
LOW TEMPERATURE (frost prevention)
FULLTANK (safety tank full)
PROBE FAILURE (sensor damaged)
Troubleshooting