依照下列程式定期進行日常檢查及保養。
保養前
預備工作
注意
關掉主氣體及冷熱水閥門，切斷電源供應及待熱水
器冷卻。
1
關掉主開關。
2
關掉主氣體及冷熱水閥門。
3
切斷電源。
4
熱水器冷卻後，進行下列步驟。
保養
熱水器
注意：切勿用苯或稀釋劑。
Carry out the daily inspection and maintenance regularly following the procedure described below.
Before maintenance
Preparations
Cautions
Close main gas and water valves, plug out power
supply and wait until the heater is cooled down.
Turn off the main switch.
Close main gas and water valves.
Plug out power supply.
Carry out the following after the
heater is cooled down.
Maintenance
Heater
Wipe the heater with swab or towel using
a kitchen cleanser.
Note: Do not use benzen and thinner.
用刷掃或毛巾加廚房清潔液揩抹熱水器。
Daily inspection and maintenance
日常檢查及保養
13
Operation Manual
6
Operation Manual
緊固地插入。
熱水器可能有問題。
間中清潔電源插的塵埃。
若電源插積聚塵埃，潮濕導致絕緣降低而可能引致生火。
切勿破壞電源線及電源插。
若使用損壞的電線及電源插，可能導致觸電，短路及生火。
確定電路不超載。
若超載，可能生熱而導致生火。
手部帶有水份切勿觸摸電插頭。
可能導致觸電。
當插入或拔出電源，確定拿緊電插頭。
若拔出或拉出電源線，電源線可能脫離而導致生火或觸電。
若使用不正確安裝或搬遷的熱水器，損壞的電源線及電源插，
可能導致觸電，短路及生火。
Plug in firmly.
The heater may be malfunctioned.
Remove dusts on the plug occasionally.
If any dust gathered on the plug, the electrical insulation
becomes poor due to humidity and may cause a fire.
Do not damage power cord and plug.
If damaged cord or plug is used, electric shock,
short-circuit and a fire may be caused.
Make sure that wiring equipment should
not be overloaded.
If overloaded, it may generate heat to cause a fire.
Do not touch an electric plug with wet
hands.
An electrical shock may be caused.
When power supply is plugged in or out, make
sure to do so by holding the plug firmly.
If you plug out by pulling the power cord, power cord
may be disconnected to cause a fire or an electric shock.
Installation or relocation of the heater must
be done by a Registered Gas Installer.
If the heater is not installed properly,electric
shock, short-circuit or a fire or a trouble may
be caused.
熱水器之安裝或搬移，必須由註冊氣體
技工進行。
WARNING
警告
Содержание GPS13 Series
Страница 1: ...Instantaneous Gas Water Heater...
