GLP
German Light Products GmbH
(instruction version
1.07)
31
6.3.4 Changing Color filters
1) The fixture is open as described above. The optical plug-in module
is taken out and opened as well.
2) Pull the Color filter holder carefully out of the central spring-holder jig.
Use for example a small flat-noses pliers or do it by hand.
Note:
This will work best if the two "open" positions are overlapping.
3) Exchange the complete Color filter holder and pull it back into the
central spring-holder jig. You can also use a small screwdriver to lift the
spring carefully.
Attention:
Please make sure that the Color filter holder is snapped in
and fits tight.
7
7
Maintaining and Cleaning the
Y
Y
P
P
O
O
C
C
7
7
0
0
0
0
It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid
residues must not built up on or within the fixture. Otherwise the fixture's light-output will
be significantly reduced or damages can occur. Regular cleaning will not only ensure
the maximum light-output, but will also allow the fixture to function reliable throughout its
life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended, under no circumstances should alcohol or solvents be used!
The inside optical system should be maintained only by authorized persons. Please
contact your local dealer.
7.1 Safety
Regulations
•
Pull out the main plug!
•
Wait min. 20 minutes after the last operation to cool down the fixture.
•
Before you put the
Y
Y
P
P
O
O
C
C
7
7
0
0
0
0
into operation close the casing, otherwise your
retina can be hurt!
7.2 Circumference and Interval (rule-of-thumb)
The contamination of the fixture depends on the environment details. Therefore no
general guidelines can be given. Therefore the intervals given are only
suggestions from our practice experience.
