GLP German Light Products GmbH
(Instruction version: 1.1) / from software version: V1.09
9
A safe and sound installation can not be assured in this way. In addition
this can damage the fixture base.
2x half-couplers
1x half-coupler
2.3 Securing the Fixture
Regardless of the mounting method of the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
X
X
4
4
S
S
you'll have to use
a stipulated safety wire. Attach the safety wire through one of the two holes
provided on the base of the fixture and connect it to the primary support
structure. Pay attention to a safe and proper fastening. The safety cable must
comply with BGI 810-3 (EN 60598-2-17 Section 17.6.6) and be capable of
bearing a static suspended load that is ten times the weight of the fixture and all
installed accessories.
2.4 Connections
2.4.1 Power
Supply
~100-240 Volt AC, 50-60 Hz, earth contact type plug
Connected load 130 VA (W)
<=>
T5A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.
2.4.2 DMX
USITT DMX-512 Standard input/output in 5-pin connectors.
Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4&5 N.C.
The DMX- Addressing starts at the DMX- Address [001].
