Gerber enVision, Руководство пользователя, Страница: 16 / 80

12 enVision Owner’s Guide
9. On the right end of the plotter, place the three closely-spaced holes on the
alignment pins of the fixed sprocket.
10. Close the rear material guide tube, then adjust (slide) the left bail so that it
lines up with the sliding sprocket on the left side. Close the bails, which
also closes the front material guide tube, making sure that the left bail is
seated over the pins of the left sprocket.
Installing tools
The knife, pen, and optional pounce tools are all installed into the tool head the
same way. Before installing the knife for the first time, or after changing the
blade, adjust the blade exposure, then load the knife. This paragraph provides
information on:
„
Adjusting the knife blade exposure
„
Installing a tool
„
Changing the knife blade
Note: The GERBER EDGE eyepiece, used to align the knife with the cutter
registration mark printed on the material, is also installed in the tool head the
same way as the tools. For more information on using the plotter with the
EDGE, refer to the paragraph "Using the enVision with the EDGE.”
Adjusting the knife blade exposure
Cut quality is directly related to the correct blade exposure for the material
being cut.
The knife tool holder has hash marks around its circumference. Rotating the
adjustment cap one hash mark, extends or retracts the blade 0.001" (1 mil)
(0.0254 mm). When the blade is pointed towards the ceiling, rotating the
adjustment cap clockwise increases the blade exposure. Turning the cap counter
clockwise decreases the blade exposure.
Rear material
guide tube