5
CAPACITOR PRECHARGE CIRCUIT
•
1 resistor, 2 ohm, 3W
•
2 6.5mm male CC Bullet
•
1 piece red shrink wrap for 6.5mm bullet
•
1 piece black shrink wrap for 6.5mm bullet
•
red wire, 16awg
•
assorted shrink wrap
Caution: When working with batteries, always keep one exposed contact covered to
avoid short circuits. Instructions
a. Watch
How to Solder Bullet Connectors
b. Solder 6.5 mm male bullets to ESC leads. The leads may already be tinned by the manufacturer
and might be too large for the bullet connectors. Before attempting to solder into the socket,
you may want to shave off some of the solder until the leads will fit into the socket without being
heated.
c. Apply heat shrink for 6.5mm bullets to ESC leads.
d. Cut 2, 2.5-inch pieces of the red 16awg wire. Solder one male/female 4mm connector to each
wire piece, and heat shrink the connectors
e. Cut the 2 ohm resistor leads down like shown. Bend one lead down like shown.
7
Содержание AutoRally
