Geometrics G-877, Руководство по эксплуатации

Страница: 36 / 49

When the system is in the configure mode it will display a prompt that looks like "->", at which
the user may type a single character to select the item to be set (character set listed below).
When the character is typed, the system will respond with the current value of the parameter and
allow the user to edit the value or press return to retain the old value. Section 4.5 lists the
messages that can be displayed during the configuration process and their meanings. If an entry
is in error, you will have to proceed down through the menu of changes and restart. If entries are
out of bounds, a comment will appear.
Note: If instead you see "CHECK SUM ERROR ", this means that both primary and backup
parameter blocks in the FLASH have been corrupted. You will need to go into the configure
mode and set all the parameters correctly and save them before you can run.
In many cases, pressing a character will cause a
list of items to be sent and/or set before
returning the prompt. A few moments may be
required before you get a response.
Once finished with the configuration changes,
save the new configuration into FLASH by pressing the character "S" at the prompt. If you
don't save the changes now, they could be lost should power inadvertently be removed from the
system. During the save process, the software checks for proper ranges in the new configuration
and will not download erroneous or out-of-range values.
Warning:
A space and return, i.e., " <return>" is
not the same as "<return>".
After the checking, the software requires that you
press a "Y" to write data to the FLASH . If
you inadvertently disconnect power during the download, the results can be difficult to predict,
but significant effort may be needed to reinitialize the system. When the prompt comes back it is
safe to turn off the power.
36 G–877 MARINE MAGNETOMETER OPERATION MANUAL