7
APPENDIX C - BATTERY PACK REPLACEMENT INSTRUCTIONS
Note the following instructions:
1)
Remove the eight phillips-head screws on the face panel.
2)
Pull out the face panel (the panel fits very tightly in the box and may have to be
pried out carefully with a screwdriver).
3)
Remove the four Phillips-head screws from the bottom of the box.
4)
Carefully pull the pack from the box (it is a tight fit).
5)
If a new pack has been supplied, connect the leads to the readout assembly and
reverse the above steps. If just the battery has been purchased, the old battery
must be removed from the pack and the new one wired in the same manner, and
glued into the pack before putting the pack into the case. (RTV holds it in place
very nicely).
NOTE: The only screws that should be removed from the outside of the GK-401 are
the 8 screws on the face panel and the four screws on the bottom of the box. All
others are meant to remain permanently.
