TrueView 435 Hardware User Guide
36
TrueView 435 Hardware User Guide
10/26/2021
Figure 49 - Heading Alignment Maneuver
7.
After Landing
1.
After landing the SYS LED should be flashing yellow, indicating the system is transferring data.
Do not power off the system during this time or it will interrupt the data transfer.
a.
If proximity mode is disabled or the aircraft does not land within 25 meters of the home
point, the SYS LED will be solid green after landing. Press and hold the green button on
the TrueView controller box until the system LED changes from solid green to flashing
yellow.
2.
The flashing yellow light indicates the TrueView is writing data to the USB drive. Be sure not to
power off the TrueView or remove the USB drive during this period.
3.
When the system LED changes to solid yellow, the flight data has been transferred to the USB
drive.
4.
Power off the TrueView with the power switch in the battery compartment.
5.
For missions requiring multiple
flights, repeat these steps from the “pre
-
flight” section of this
document. The system should be completely powered off between flights (battery swaps) after
the data has been successfully written.
6.
Check the data for errors before leaving the field.
7.
Field check the data to verify all data has been collected. The Field check instructions can be
found in the
