LFP Battery Module – Product Manual
All rights reserved genZ 2020
Issued for Use
Revision
Page
4/03/2020
2.1
9 of 25
6.8
Rackmount Configuration
Use the included rackmount tray, brackets and screws to mount the Battery Module in a rack by
following the steps below.
1.
Install the tray into the rack using appropriate rack mounting screws. Note that these screws
and caged nuts are not supplied.
2.
Install the tray supporting rails and attach to the racks rear vertical mounting post using
appropriate rack mounting screws.
3.
Using the supplied screws, tighten the rail to the tray.
4.
Slide the battery module into the tray.
5.
Attach the battery module retaining plates using rack mount bolts (not supplied). Attach the
battery module retaining plates to each side of the battery module. Use of split washers maybe
required where the modules are retained in areas of movement or vibration.
NOTE: Failure to install the tray supporting rails may result in failure of the battery module tray.
6.9
Connecting the Battery Module
(QUALIFIED SERVICE PERSONNEL ONLY!)
1.
Ensure that the battery module circuit breaker is in the OFF (lever down) position.
2.
This should also be confirmed by seeing that the green LED is OFF.
3.
Attach an earth wire (if required in your design) to the earth point, located just below
connector J1. An alternate earth point is also located on the rear of the module.
4.
Inspect for any damage to cables or connectors.
5.
Connect the Power In/Out J1 connector by firmly pushing the plug straight into the socket.
