2
S e t U p / / G T S k y L o f t
Step 1
Before mounting on your vehicle, unzip and remove the cover to find where the
Velcro ladder strap is on the platform base. These straps are beneath your
entrances to your Sky Loft. There are two of these ladder straps on the base. Mount
the Sky Loft on your vehicle in the direction that it suits you best.
If mounting length ways across your vehicle, you will require a third roof bar to
support the front section of your platform. If you chose to mount across your
vehicle, a second ladder is needed at the opposite entrance to ensure added
stability to your Sky Loft.
Mount the Sky Loft onto your roof racks using our supplied mounting brackets
ensuring all the bolts are tight and secure before you attempt to inflate the base.
Step 2
Unclick the 3 belt buckles and unfold all sides of your GT Sky Loft.
Step 3
Your inflation point is on the underside of the base. Be sure to turn the valve until it
is protruding out before you begin inflation. If you do not do this, air will escape
when you remove the connector after inflation.
Step 4
Using the supplied pump adaptor connection, attach this to your 12-volt pump. Push
in and twist the connector into the inflation point on the base. Inflate to between 8 –
10 psi. Do not exceed 11 psi.
Step 5
Once the desired pressure is reached, turn your connector to the left to release from
the valve. Close tightly with the attached cap.
Step 6
You are now ready to attach your telescopic ladder underneath the entry of the GT
Sky Loft. Extend the ladder using both hands either side and lifting each step up until
the desired height is reached.
Step 7
Place the extended ladder up underneath the smaller section of the Velcro making
sure the Velcro is tightly wrapped around the top rung of your ladder and fold over
the secondary larger piece of Velcro. If mounting laterally, please repeat this process
for both sides as the Sky Loft requires the support from both ends.
