3
Step 8
Your GT Sky Loft has 2 separate inflation tubes. Locate the inflation points on the
outside of the tent (under the Velcro flaps). There are also inflation points inside the
tent. Ensure that the opposing valve on each of the inflation tubes are closed before
inflating your Sky Loft.
Step 9
Change your quick release adapter on your pump to the large round connector that
is supplied.
Step 10
Before connecting, ensure that the blue tab inside the valve is flat and not pushed in
from your last deflation. Once this is completed, push in the adaptor firmly to your
inflation point. Set the pressure on the gauge to 3 psi and inflate. Pressure must be
between 3 – 3.5. Do not exceed 3.8.
Step 11
To remove the fitting, simply twist and pull, making sure to close tightly with the
attached cap.
Step 12
Once you have inflated both sides of your Sky Loft, you will need to attach the 3 inner
support tubes via the Velcro attachments. After the initial instalment of the support
tubes, these can remain in place for future pack downs. Inflate these 3 tubes to the
same pressure.
Step 13
Finally, inflate your nosecone using the same connector as the upper tubes until the
tube is hard.
Step 14
Guy lines are attached for your comfort if you need more stability.
Step 15
For using the supplied storm cover, please attach it to your GT Sky Loft after you
have inflated the mattress/base and before you inflate the rest of the tubes.
You are now ready to enjoy the views and lightweight spirit from our GT Sky Loft.
