page 7
Genquip Gi2000 Digital Inverter Petrol Generator
Operation
Starting The Engine
NOTE:
Before starting the engine, ensure you have fi lled the crankcase to the correct
level with oil. The crankcase is not fi lled with oil from the factory.
1.
Before starting, ensure that no electrical apparatus has been connected.
2.
Turn the fuel cap vent lever to the on position
(Fig.G)
.
3.
Turn the engine switch to the on position
(Fig. H)
.
4.
To start a cold engine move the choke lever to the start position. In order to restart a
warm engine, leave the choke lever in the run position
(Fig. I)
.
5.
Slowly pull the recoil starter
(6)
until you feel it engage and then pull it briskly.
Return the recoil starter gently and slowly to the original position by hand.
NOTE:
When the motor is started for the very fi rst time, it will require a number of
attempts to start until the fuel has traveled from the tank to the motor.
6.
If the choke lever was on the start position gradually move it to the run position as the
engine warms up
(Fig. K)
.
Figure G.
Figure H.
Figure I.
Figure K.