Part No. 133554
Genie TZ-34/20
29
Operator’s Manual
Fourth Edition • Fourth Printing
Inspections
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator’s
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to use.
4
Inspect the workplace.
Know and understand the workplace
inspection before going on to the next
section.
5 Only use the machine as it was intended.
Workplace Inspection
Fundamentals
The workplace inspection helps the operator
determine if the workplace is suitable for safe
machine operation. It should be performed by
the operator prior to moving the machine to the
workplace.
It is the operator’s responsibility to read and
remember the workplace hazards, then watch
for and avoid them while moving, setting up and
operating the machine.inspection before using the
machine.
Emergency Stop
Push in the red Emergency Stop button to the off
position at the ground or platform controls to stop
all machine functions.
Repair any function that operates when the red
Emergency Stop button is pushed in.
Selecting and operating the ground controls will
override the platform red Emergency Stop button.
Setup
Make sure the machine is properly set up and
tested. See Function Tests section.
Workplace Inspection Checklist
Be aware of and avoid the following hazardous
situations:
Drop-offs or holes
Bumps, fl oor obstructions or debris
Sloped surfaces
Unstable or slippery surfaces
Overhead obstructions and high voltage
conductors
Hazardous locations
Inadequate surface support to withstand all
load forces imposed by the machine
Wind and weather conditions
The presence of unauthorized personnel
Other possible unsafe conditions
