Part No. 133554
Genie TZ-34/20
17
Operator’s Manual
Fourth Edition • Fourth Printing
Do not operate a boom in the path of any crane
unless the controls of the crane have been locked
out and/or precautions have been taken to prevent
any potential collision.
No stunt driving or horseplay while operating the
machine.
Explosion and Fire Hazards
Do not operate the machine in hazardous
locations or locations where potentially fl ammable
or explosive gases or particles may be present.
Component Damage Hazards
Do not use the machine as a ground for welding.
Do not fully lower the booms unless the booms are
aligned with the tongue. The primary boom must
be lowered into the chassis cradle.
Damaged Machine Hazards
Do not use a damaged or malfunctioning machine.
Conduct a thorough pre-operation inspection of
the machine and test all functions before each
work shift. Immediately tag and remove from
service a damaged or malfunctioning machine.
Be sure all maintenance has been performed
as specifi ed in this manual and the appropriate
service manual.
Be sure all decals are in place and legible.
Be sure the operator’s, safety and responsibilities
manuals are complete, legible and in the storage
container located on the platform.
Bodily Injury Hazard
Do not operate the machine with a hydraulic oil or
air leak. An air leak or hydraulic leak can penetrate
and/or burn skin.
Improper contact with components under
any cover will cause serious injury. Only
trained maintenance personnel should access
compartments. Access by the operator is only
advised when performing a pre-operation
inspection. All compartments must remain closed
and secured during operation.
Towing Hazards
Read, understand and obey all of your tow vehicle
manufacturer’s recommendations, warnings and
instructions before towing this machine.
Make sure your tow vehicle is properly maintained
and capable of towing this machine.
Be sure the hitch is properly and securely attached
to your tow vehicle.
Do not overload your tow vehicle. Observe the
manufacturer’s Gross Vehicle Weight Rating
(GVWR).
Be sure all lights, mirrors and hitch components
conform to federal and local regulations.
Be sure that all driving lights are operational.
Be sure the tires are properly infl ated.
Do not tow the machine unless the boom is
lowered into both cradles and the hold-down
latches are securely locked in place. There is a
mast cradle on the chassis and a mid-pivot cradle
on the tongue of the machine.
Do not load cargo on the machine. The TZ is not
designed to carry any extra cargo.
Be sure the safety chains (if required) are securely
attached to the tow vehicle. Cross the chains
under the hitch. This will create a cradle to catch
the tongue of the trailer if it becomes disconnected
from the tow vehicle.
Work Area Safety
