28
Network Camera User Manual
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of
the detected objects should not be more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial to line crossing detection.
4.5
Network Configuration
4.5.1
TCP/IP
Go to Config
Network
TCP/IP interface as shown below. There are two ways for network
connection.
Use IP address (take IPv4 for example)-
There are two options for IP setup: obtain an IP
address automatically by DHCP protocol and use the following IP address. Please choose one
of the options as needed.
Test: Test the effectiveness of the IP address by clicking this button.
Use PPPoE-
Click the “PPPoE Config” tab to go to the interface as shown below. Enable
PPPoE and then enter the user name and password from your ISP.
Either method of network connection can be used. If PPPoE is used to connect internet, the
camera will get a dynamic WAN IP address. This IP address will change frequently. To be
notified, the IP change notification function can be used.
