22
Network Camera User Manual
3. Click “Enable” and set the alarm holding time.
4. Set alarm trigger options. Trigger Email and FTP. The setup steps are the same as
motion detection. Please refer to motion detection chapter for details.
4.3.3
Alarm Server
Go to Alarm
Alarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the camera
will transfer the alarm event to the alarm server. If an alarm server is not needed, there is no
need to configure this section.
4.4
Event Configuration
For more accuracy, here are some recommendations for installation.
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of
detection.
Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass,
lake surfaces and so on).
Avoid places that are narrow or have too much shadowing.
Avoid scenario where the object’s color is similar to the background color.
At any time of day or night, please make sure the image of the camera is clear and with
adequate and even light, avoiding overexposure or too much darkness on both sides.
4.4.1
Object Removal
Alarms will be triggered when the objects are removed from or left at the pre-defined area.
To set object removal:
Go to Config
Event
Object Removal interface as shown below.
