Genie IntelliG 1000, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 14

9
©2011 The Genie Company 9/2011
CORRECTIVE MAINTENANCE
TO ENGAGE , PULL
DOWN AND TOWARD
POWERHEAD . CHECK THE
RED BLOCK IS IN THE UP
POSITION. THEN LET GO.
TO DISENGAGE , PULL
DOWN AND TOWARD
DOOR . CHECK RED
BLOCK IN THE DOWN
POSITION. THEN LET GO.
DOOR DOOR
DISENGAGING AND ENGAGING CARRIAGE
CHANGE LIGHT BULBS
WARNING
s
When replacing light cover, make sure wires are
not pinched or near moving parts.
s
Use extreme caution when working from a ladder
or step stool.
1. Disconnect power to door opener.
s/PENP
owerhead light cover.
s2EM ove light bulb(s).
s2EPLA
ce light bulb(s).
– Do NOT use light bulbs with greater than
100 Watt rating.
s#LOSEP
owerhead light cover.
2. Reconnect power to door opener.
s
Test light operation.
RESET - OPEN/CLOSE TRAVEL LIMIT
Performing all ten (10) Limits/Force setting steps
(page 5) erases previous Limits/Force settings.
NOTE: The opener will not close the door
automatically unless the Safe-T-Beam® System is
installed and Limits are programmed.
CHAIN OR BELT - TENSION ADJUSTMENT
WARNING
s
Observe all safety warning and precautions!
s
Disconnect power from opener and disconnect
carriage in rail from bullet before beginning this
task.
Visually inspect the chain or belt every 6 months.
NOTE: Tension adjustments should be made with the
door in the down position and the carriage released.
s
At the center of the rail the chain or belt should
not be resting on the rail. See adjustment
illustration on right.
– With the bullet NOT engaged to the carriage,
tighten adjustment nut until chain/belt does
not, at the center of the rail, rest on rail. Do NOT
overtighten.
s
Is there rust on chain or frayed edges on belt?
– Contact a trained door system technician for
chain/belt replacement.
s
Are there kinks or twists in the chain or belt?
– Contact a trained door system technician for
chain/belt replacement.
Tighten nut to increase
tension on chain or belt
Chain
Chain
Chain at center of rail
Approx. 1/8"
Adjustment required
Correctly adjusted
Belt
Belt
Belt at center of rail
Approx. 1/8"
Adjustment required
Correctly adjusted
BELT
CHAIN
REMOTE BATTERY REPLACEMENT
Replace remote battery with a
CR 2032 coin cell battery.
1. Open the remote case
using a washer or coin
that fits into the slot at
the top of the remote
2. Replace battery.
3. Align components and
snap case closed.