Genie GS-2646 AV, Руководство оператора

Страница: 33 / 57

Second Edition • Second Printing Operator's Manual
Inspections
Part No. 1274894GT GS-2646 AV • GS-2646 AV35 31
61 Close the rear entry gate.
62 Open the front entry gate and prop open.
63 Press the drive function button
(if equipped).
64 Press and hold the function enable switch on
the control handle.
65 Slowly move the drive control handle in the
direction indicated by the blue arrow, and then
in the direction indicated by the yellow arrow.
Result: The machine should not move in the
direction indicated by the blue arrow, or the
yellow arrow.
66 Press and hold the drive/steer function enable
switch on the control handle.
67 Press the thumb rocker switch on top of the
control handle in the direction indicated by the
blue triangle, and then in the direction
indicated by the yellow triangle.
Result: The steer wheels should not turn in the
direction indicated by the blue triangle, or the
yellow triangle.
68 Activate the platform up function, and the
platform down function.
Result: The platform up function and the
platform down function should not operate.
69 Activate the platform extend function, and the
platform retract function.
Result: The platform extend function and the
platform retract function should not work.
70 Close the front entry gate.
71 Fully retract the powered extension deck to the
stowed position (if equipped).
Fully lower the platform to the stowed position.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
72 Fully lower the platform.
73 Place a 2x4 or similar piece of wood under
both wheels on one side and drive the
machine up onto them.
74 Raise the platform approximately 7 ft / 2.1 m
from the ground.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
75 Press the drive function button
(if equipped).
76 Press and hold the function enable switch on
the control handle.
77 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
78 Lower the platform and remove both pieces of
wood.