ⓒ
2020
LaON
Technology Co., Ltd. All rights reserved.
67
14.
3.5mm TRS Headset (Earphone and Mic) connector
This is one additional TRS headset port. The function is the same as the headset port (#14), and the microphone and
earphone level can be adjusted independently of headset (#14).
Pinout
8.2 Operating the Ethernet Beltpack IBP10
1.
2. 3. 4. Talk keys (LED indicator)
The user can specify that the latch is enabled or disabled on the Talk key. And the user can set the GENIE group channel,
Relay, or Opto-isolated Input on the Talk key.
See this manual, Set Latched Talk menu. Or see GCM user manual, 1.1.6 Configuring the Ethernet Beltpack.
The Talk keys themselves act as status indicators. The status LEDs signal is as following.
Note:
LED status for Call
In the case of an incoming call from the last caller, the LED flashes red until any key is pressed.
When making a call signal, The LED is lit solid red for 3 seconds.
5.
Call button
Press to send a call signal each intercom or wireless device.
When the Call button is pressed, the call signal is sent to the Talk channel that is currently active and the Talk
channel that is active within 5 seconds.
6.
Volume up button, Shift Talk channel (Press 3 sec)
7.
Volume down button, Shift Talk channel (Press 3sec)
8.
Channel 2,4 volume select
9.
Channel 1,3 volume select
Master volume:
To increase the volume level, press Volume up button (#6). To decrease the volume level, press Volume down
button (#7).
Talk channel 1 or 3 listen level:
Talk channel 2 or 4 listen level:
Press to select each Talk channel to increase or decrease the listen level.
Press the Left (# 8), Right (# 9) Volume select button on the Normal screen to select a Talk channel. The
corresponding Talk channel flashes slowly. Press Left (# 8) button to select a Talk channel 2 or 4. Press Right
(# 9) button to select a Talk channel 1 and 3. Navigate to the Talk channel to adjust the listen level with the Left
or Right button. Use the Up or Down button to adjust the listen level for the corresponding Talk channel. Press
the Menu button to return to the normal screen.
Shift Talk channel:
Press the Up or Down button for 3 seconds. Four Talk channels on the other page are shown alternately on
the Beltpack screen.
Press to toggle between Talk channel page 1 and page 2. Page 1 displays Talk channel 1
through 4, and Page 2 displays Talk channel 5 through 8.
The LED in the Talk key displays green on page 1 and orange on page 2 when listen path is active.
Pin
Description
Tip
Ea (Left)
Ring
Ea (Right)
Ring
Ground
Sleeve
Mic +
LED state
Description
Display
Solid red
A talk path is active
Channel label and listen level
Green flashing slowly
Talk channel is on page 1, and received audio above VOX level
Channel label and listen level
Solid Green
Talk channel is on page 1, and a listen path is active
Channel label and listen level
Amber flashing slowly
Talk channel is on page 2, and received audio above VOX level
Channel label and listen level
Solid amber
Talk channel is on page 2, and a listen path is active
Channel label and listen level
Red flashing slowly
Call signal received.
Channel label and listen level
LED is off
Talk channel is not assigned.
‘Not set’
Not paired
‘Not paired’
Not linked
‘Unlink’
Channel is busy (When press Talk key, LED is not on)
‘Channel is busy