Genie BP850 Скачать руководство пользователя страница 38

Страница: 38 / 86

ⓒ

2020

LaON

SetBase menu

GN ELECT DYN:

In the menu, select Electret (ELECT) or Dynamic (DYN) to set the type of Gooseneck microphone.
To save the selected setting, press rotary control or scroll to the next item.

Call Tone on off:

In the Call Tone menu, select On (enable) or Off (disable). When enabled, the user can hear the tone when a
call occurs. To save the selected settings, press rotary control or scroll to the next item.

Low Cut off -3 -6:

In Low Cut menu, you can set the cutoff level of low-frequency audio such as wind noise and air conditioning.
The maximum cutoff level is -6dB.

VOX Level:

To set the VOX level.
If the audio level of the Talk channels is higher than this level, the audio is detected, and the Talk key LEDs
flash green. The same level applies to Ethernet Beltpack.
Selection range: 0: disable, 1 through 9 (From -58dB to -10dB)

Latched Talk:

The user can set on the Talk key that the latch is enabled or disabled. If each Talk channel number is selected, the latch
can be enabled. If the latch is disabled (Momentary) the Talk path is only open while the Talk key is pressed. If the latch
is enabled, quickly tapping the Talk key will latch a key, and a second tap will release it.

Sidetone Option:

Track (default): The sidetone level will track the master volume level.
Non-track: The sidetone level is fixed to the set level.
If sidetone level is set to zero, it is muted.

A 4-Wire 2-Wire
B 4-Wire 2-Wire:

Before using a Line, Line type should be set to ensure that the volume level and the call signal operate normally.
In the menu, select the 2-Wire or 4-Wire to set the type of the Line. To save the selected setting, press rotary
control or scroll to the next item.

Screen Save:

Set the time period when the screen will automatically turn off.
Selection range: 10 to 900 minutes (10 minutes per step)
The Base Station display will turn off if key is not used or there is no incoming call during a set time period.

RF-TX On Off:

Turn off Base Station radio transmission

Select Off if the Base Station does not need to transmit and receive radio wave.

Note:

Cannot pair with Beltpack in RF-TX Off state. Change to RF-TX On when pairing with the Beltpack.

Indoor-RF On Off:

Select RF channel

On 5GHz UNII RF bands, there is a separate definition and guideline for RF band to be used in indoor
environments. Select On if you use the system at any indoor environments. When using the system at any
outdoor environments, Off should mandatorily be selected. Selecting On allows the use of the indoor and
outdoor RF bands.
See 3.3 Placing the Base Station, Remote Antenna and Repeater, Frequency band

Note:

Upon the change of the setting of indoor or outdoor, the Base Station should be rebooted.

Multi-BS MST SLV:

Using multiple Base Stations in an Antenna coverage zone.

The GENIE is designed so multiple Base Stations, Remote Antennas and Repeaters can work in one antenna

coverage. To ensure smooth coexistence of these devices, you will need set the Ethernet synchronization

and connecting the Multi-Sync cable. If multiple Base Stations are connected by Multi-Sync cable, a Base Station

should be set to 'Primary on' (Master) in the Multi BS menu and all other Base Stations should be set to 'Primary off'

GN ELECT DYN

Call Tone On Off

LowCut off -3 -6

VOX Level 1