14
Patented seat post with one-screw locking mechanism
Patented seat post with two-screw locking mechanism
Setting up the angle of the seat
When you have set the height of the seat, you
have to check that the angle of the seat is suitable.
In general, the upper surface of the seat should
be horizontal. You can adjust this by loosening the
clamping bolts in the seat post.
Attachment with seat clamp
Suspension seat post
Integrated Seat Post
If your bike is equipped with a so-called “integrat-
ed seat post”, which can otherwise be described
as a seat post with integrated fixing, then read
the component manufacturer’s enclosed instruc-
tions to assist you with the setup.
Before you start riding, please test to
see if your seat post and seat are se-
cure. To do this, hold the seat at the
front and back and attempt to turn it. It should
not move.
* see page 40
/
7.5 cm
When adjusting the height of the
seat, never pull the seat post further
out than the maximum extension
length marked! If your tube does not have a
maximum marking, then you must leave a
minimum insertion length of 7.5 cm.
If your mountain bike
is equipped with a tel-
escopic seat post, read
the manufacturer’s en-
closed instructions be-
fore use.
For information concerning the in-
stallation and service of threaded
and telescopic seat posts, read the
manufacturer’s service manual.
STOP
Содержание Children's bike
Страница 62: ...58 Notes...
Страница 63: ...59...
Страница 64: ...60 Notes...
Страница 67: ...U7 Please read Make note of the bicycle identification and delivery document Notes...