4
INSTALLATION
This unit is designed to be installed as a wall-mount unit or set on a flat surface.
Installation must be completed by competent personnel.
Genesis Air, Inc. assumes
no liability for damages or injuries sustained from installations done by
other than qualified Genesis Air technicians
.
For a wall-mount application, determine where this unit is to be hung. This unit
has keyholes for a horizontal hanging only. On the rear panel of the unit, there
are 2 keyhole slots 11 15/16” apart.
Install 50 lb. rated wall anchors in the position determined.
Using a helper, hang the 2006D&L on the wall anchors
Plug in the unit or wire permanently using the wiring diagram below. Run the
unit at all speeds, ensuring the fan has not bound during shipping. You should see
a blue glow thru the plastic window at bottom of the unit.
MAINTENANCE
LAMPS
ALL UNITS MUST BE POWERED DOWN BEFORE SERVICING.
ALL MAINTENANCE PERSONNEL MUST WEAR UV PROTECTIVE
SAFETY GLASSES. ALL EXPOSED SKIN MUST BE PROTECTED BY UV
RESISTANT CLOTHING.
GENERAL
To operate effectively, the lamps must be replaced each year, as the intensity of the lamps
decreases over time. The catalyst must be energized by the lamps to create the field of
hydroxyl radicals that is required to remove VOC’s and biologicals. Without the proper
lamp output, VOC’s and biologicals will not be reduced!
INSPECTION
The clear plug in the front of the unit will emit a blue glow if the lamps are
operating. If one lamp is defective, neither lamp will light.
Power the Genesis Air unit down using the kill switch or breaker to
unit.
Open the front grille and remove the air filter and UV shield/catalyst assembly.
If a lamp appears blackened at one end, replace the lamp with a Genesis Air
UVCHO18W.
Ensure each lamp is plugged in firmly to receptacle.
Replace catalyst/UV shield and filters in proper orientation and close the grille.
Power up the unit.
