9
In
stallation
8
1.4 Connecting Accessories (optional)
• By connecting a headset to the hand-
set you can make a "hands-free” call.
• An add-on vibration signal can also be
used to indicate incoming calls. If des-
ired, the ringing tone of your phone
can be disabled and people around you
will not be disturbed by incoming calls.
Information on the connection and use of
accessories is included with the devices.
1.5 Recommended First Steps
Although your telephone is ready for use
immediately after connecting the base
station and allowing the batteries in the
handset to charge, you should adapt it to
your own special requirements by adju-
sting a small number of settings.
The following steps are necessary, in
order to prepare your Genery ISDN for
your local requirements.
As the language preset of the handset is
German, the first thing to do after the
installation of cables and batteries has to
be the selection of the appropriate lang-
uage:
1.Press the menu key
2.Scroll down to the menu item ‚Einstel-
lungen‘
3.Press the OK key
4.Scroll down to the menu item ‚Sprache‘
5.Press the OK key
6.Select the desired language
7.Press the JA key
8.Leave the menu by pressing the menu
key
• After that you have to select the coun-
try preset for your country, in order to
determine the correct ISDN- and coun-
try code settings. (see chapter 5.7.2)
• In the next step you have to enter your
local area code. This is not necessary, if
your telephone network works with
closed user groups. (see chapter 5.7.3)
• Finally you have to program your ISDN
numbers (MSNs). (see chapter 5.7.4).
• For operation with a private telecom-
munications switching system (PABX)
see chapter 5.7.6
• For operation with several handsets see
chapter 5.10.2
• To specify a call charge factor see
chapter 5.7.7
• To change the PIN see chapter 4.7.1
1.2 Connections
Connect the cables to the base station.
Plug the equipment end of the power
supply cable and the telephone cable
into the appropriate sockets on the
underside of the base station. Now insert
the other end of the telephone cable into
the phone jack and the plug-in power
supply into a wall socket.
Use only the SNG 10 W / SNG
10 WGB plug-in power supply
provided.
1.3 Inserting the Batteries
The battery compartment has a lid with a
snap catch.
Open the battery compartment on the
back of the handset by pressing the cover
at the point marked
➀
. Then flip up the
lid
➁
and pull it in the direction of
➂
.
Insert the batteries the right way round
(correct polarity) and close the battery
compartment again. To do this, push the
two lugs at the end of the lid into the
recesses in the housing and lower the lid
until it audibly snaps into place.
Place the handset onto the charging /
base station with the keypad facing
towards the front and allow sufficient
time for the batteries to charge up before
you use the telephone for the first time
or make a setting.
• Make sure you insert batteries
of the same type, the same
capacity and with the correct
polarity.
• Never use the handset with the
battery compartment open.
• Never place the handset in the
charging station / base with the
battery compartment open.
• Do not use alkaline batteries.
1
3
2
