General Excalibur 40-200C, Руководство по установке и эксплуатации, Страница: 21 / 38

Note: When mounting the Milwaukee model 5625/5626
motor, please ensure that a shim
D
is between the router
and the clamping surface of the lift.
5. Slide the router motor into the clamping area as
shown above using shim or reducers if necessary.
D
D
4.
Turn Allan cap screw
A
counter clockwise to
loosen clamp body
B
. The two threaded nuts
C
are there to help spread the clamp body.
Note: Spread clamping mechanism only as needed. Nuts
C
have no other purpose and you will notice that they are
locked together and will sit in a neutral position when the
router motor is secured into place.
A
C
B
Note: Some motors have pins or protrusions
E
on the
housing. You will need to turn/twist the motor as you
slide it into the clamping area, or onto the reducer collar.
For installation with reducer collar
1
. Install the collar onto the router as shown in
F
, and
then fit the router with collar into the lift, G , making
sure that the collar flange sits flush against the
clamping bracket.
F G
E
E
E
2.
Adjust the height of the router in the collar
H
to
ensure that the router is as close as possible to the
underside of the plate without touching
I
.
Close but not touching
3. With the router in position, tighten clamping bolt J
securely, using a using a 8 mm Allen key, but do not
over tighten. Important: Test that the router is se-
curely clamped in the reducer collar by trying to
twist the router in the collar by hand.
21
H
I
tighten
J