General Excalibur 40-200C, Руководство по установке и эксплуатации, Страница: 13 / 38

ASSEMBLY INSTRUCTIONS -
TABLE 40-075/40-049/40-045
There are 3 different table options for Deluxe Router Table Kit, model 40-200:
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COM-
PLE-TED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED
TO DO SO.
Cast-iron table (#40-075) for 40-200C MDF table (#40-049) for 40-200M
Phenolic table (#40-045) for 40-200P
The protective coating on the cast-iron table, prevents
rust from forming during shipping and storage. Remove
it by rubbing with a rag dipped in kerosene, mineral
spirits or paint thinner. (Dispose of potentially flammable
solvent-soaked rags according to manufacturer’s safety
recommendations.)
A putty knife, held flat to avoid scratching the surface,
may also be used to scrape off the coating followed by
clean-up with solvent.
To prevent rust, apply a light coating of paste wax or
use regular applications of any after-market surface pro-
tectant or rust inhibitor.
Tip: With a screw driver, push a solvent-saturated rag
into the T-slots to remove the grease.
CLEANING THE CAST-IRON TABLE FOR #40-200C ONLY)
INSTALL THE TABLE (CAST-IRON TABLE #40-200C AND PHENOLIC TABLE#40-200P ONLY)*
* For #40-049 MDF table (for #40-200M), only thread in all leveler screws and nuts as shown below. You will use
the wood screws supplied with your table in the upcoming steps to attach the table and dust collection box
to the stand, and the fence mounting rails to the table.
5.
As a precaution, thread in all fasteners as shown to
make sure there are no filings in any of the threaded
holes, and leave the fasteners in the underside of the
table. Only remove as assembly is taking place.
Note 1: The leveler screws need to be inserted from the
bottom of the table. The nut will sit on the top side of the
flange that the router lift/plate will rest on,
A
.
Note 2: There are 3 holes on each side of the table open-
ing, C. The two outside holes are for the leveling screws,
A, and the middle hole is used to secure a plate, or the
lift, to the table.
13
CAST-IRON TABLE 27”X 16”
#40-070
C
B
A