General 90-200 M1, Руководство по установке и эксплуатации, Страница: 21 / 40

Adjust the positionning of the upper thrust bearing as follows:
POSITIONING THE LOWER BLADE GUIDES AND THRUST BEARING
The lower blade guides and thrust bearing perform the same function as the upper blade guides and thrust bear-
ing except they do so after the blade has contacted the stock being cut.
Adjust the positioning of the lower blade guide as follows:
1. Loosen the two Allen bolts and slide the two blade
guides along the elongated hole in the mounting
bracket toward the blade.
2. Place a feeler gauge between one of the bearings
and the blade and tighten the Allen bolt until there
is a 0.02" gap left between the guide and the blade.
3. Repeat step 2 for the other guide on the other side
of the blade.
4. Loosen the lower set screw with the supplied 3 mm
Allen key.
5. Manually move the guide bearing mounting bracket in or out until the guides are at least 1/32” behind the
blade teeth. The guides must remain behind the blade teeth to prevent damage to the blade.
6. Tighten the lower set screw to secure the blade guides in position.
Adjust the positionning of the lower thrust bearing as fol-
lows:
1. Loosen the upper set screw .
2. Manually move the thrust bearing in or out until
the bearing is 1/64” behind the back edge of the
blade, then retighten the upper set screw
.
LOWER ASSEMBLY
1. Loosen the upper thumb screw .
2. Turn the micro adjust nut to move the thrust bear-
ing in or out until the bearing is 1/64” behind
the back edge of he blade , then tighten the upper
thumb screw .
RIGHT SIDE VIEW REAR VIEW FRONT VIEW
1/64"
LOWER ASSEMBLY
21