General 90-200 M1, Руководство по установке и эксплуатации, Страница: 14 / 40

Never adjust the table angle while the bandsaw is run-
ning. Turn off power first.
1. Loosen the lock handle .
2.
Turn the handwheel to tilt the table until it is at the desired
angle. (Refer to the angle indicator)
3. Tighten the lock handle to lock the table in position.
TILTING THE TABLE
The table can be tilted to any angle from 0° to 45° to the right , to
allow for any type of bevel (or angle) cutting. Refer to the table tilt
angle indicator on top of the bandsaw table
to set the angle of
the table to the desired position.
TABLE TOP VIEW
45°
TABLE UNDERSIDE VIEW
LASER LINE MARKER
This model 90-200 is equipped with a laser line marker, located on
the front right side hand of the upper wheel cover door
, allow-
ing you to easily mark a straight cut line on your workpiece.
Note: Requires two AAA batteries (not included). Slide upwards and
remove the battery cover
.
Align the laser beam on the blade as follows:
1.
Move ON/OFF switch up to turn the laser marker on.
2.
Move the beam adjustment knob in any direction until
the beam is aligned with the blade .
ADJUSTING THE BLADE GUARD FOR DEPTH OF CUT
The blade guard can be moved up or down to accommodate the height of the work to be cut. To prevent the
blade (which is flexible and which would not otherwise be supported) from slipping out of position during cutting,
and to reduce risks of injuries, a minimum amount of blade should be exposed.
The blade guard should be set 1/8” - 1/4” above the workpiece
to prevent the blade from flexing out of position or off-line during
cutting.
Adjust the height of the blade guard to suit the thickness of the
workpiece as follows:
1. Make sure the bandsaw is turned off and the power cord is
disconnected from the power source.
2. Loosen the smaller lock knob .
3. Move the blade guide assembly up or down by turning the
adjustment knob
. Then re-tighten the lock knob .
1/8” - 1/4”
workpiece
ON / OFF SWITCH
BEAM
ADJUSTMENT KNOB
CLOSE UP
ON
OFF
WORKLIGHT
The goose neck style worklight on this model 90-200 provides
extra lighting for added convenience. It can be repositionned, ,
for optimal lighting of the work surface.
Note: Uses a standard 40 Watt (maximum) 120 volt appliance bulb
- Not Included.
To reduce the risk of fire, use 40 Watt (maximum) 120 volt
appliance bulb. Do not use standard household bulbs.
- Turn the ON/OFF switch once to turn the worklight ON :
- Turn it once again to turn the worklight OFF :
14